Glider rocking chair is moving with a forward motion and backward sliding. Chair is fixed to side supports of base, which are attached to a rocker. Rockers are also attached to main base unit.
How to build glider rocking chair? Print drawings base Rocker Plans. Transfer drawing labeled as “An” on sheet of 3/4 inch plywood. Cut shape of plywood with a jigsaw. This measures portion 8 1/4 inches long by 10 5/8 inches wide. Transfer drawing marked Part A in plywood, then cut out shape. Repeat this step for Part B, Part C and two matching pieces for Part D.
Mark location of mounting holes on each side. Measure 1 inch pin 12 1/4 inches using measuring tape. Tang Cut two pieces 12 1/4 inches with circular saw. Place part A horizontally at top of Part C. pilot holes in each part with electric drill and secure with screws. Insert each end of 12 1/4 inch heels on a seesaw. Place pieces for Part A at end of Part C and under edge Secure Part B. Part A to Part C and Part B with screws. Place rocker inside part A and secure with screws. Place pieces for Part D in rockers and secure bearings. Glider rocking chair is ready!