One of the classic ways to hang curtains or shades is the use of polygonal curtain rods. Traverse curtain rods make opening and closing the simplest and fastest curtains. There are two types of polygonal curtain rods. It tends to draw unidirectional navigation bars you can throw one on the left side or the right side. Installing curtain rods polygon is basically the same for both types. Here are the steps to hang your traverse curtain rods tour is as follows: Measure the width of the curtain from the first to the last corner. Measure the length of the store, leaving a margin of at least one inch from the bottom of the tent on the ground.
Take note of the measurements of both the width and length if you want to mount the cross bar on the wall; otherwise, only the width of the curtain is required. Using the final measures that were obtained, mark the wall where the brackets should be placed on the traverse curtain rods. Two-way draw crossbars using two supports, while a draw direction only using a fixation struts and supports. Drill holes for the screws in the wall and secure the necessary support. Install the curtain rod crossing the stirrups.